Clwyd

Storage and electric heater replacement in Mold

If you are weighing up storage and electric heater replacement for your home in Mold, the first step is a free survey, followed by a written quote you can compare with anyone else's.

  • from £3,245Local guide price
  • Usually 2–4 daysTypical time
  • ClwydArea
Storage and electric heater replacement in a home
  • Free survey and written quote
  • Refrigerant work by F-gas certified engineers
  • Price fixed in writing
  • England, Scotland, Wales and NI
  • Cools in summer, heats in winter

Storage and electric heater replacement in Mold

Flats and bungalows in Mold that have never had gas are the usual candidates for replacing storage heaters. In North Wales, an air-to-air system can be an efficient way to heat holiday homes and bungalows, with cooling as a bonus.

For Mold landlords, swapping storage heaters for a heat pump is one of the more effective EPC improvements. Mold is about 10 miles from Wrexham and falls within our Clwyd coverage. Coverage includes CH7.

Prices in Mold

Storage and electric heater replacement in Mold typically comes in at £3,245–£9,795 for 3–5 rooms including VAT, based on North Wales rates. That sits a little below the UK middle, reflecting typical North Wales labour rates. What moves a quote in Mold up or down is mostly pipe length, how high the outdoor unit goes, and whether a new electrical circuit is needed. For reference, the Bungalow or house option in Mold (four rooms on one outdoor unit) usually comes to about £4,645–£7,445.

Small flat

£3,245–£5,095
inc VAT, North Wales guide

Two or three rooms replacing storage heaters.

Balanced choice

Bungalow or house

£4,645–£7,445
inc VAT, North Wales guide

Four rooms on one outdoor unit.

Larger home

£6,545–£9,795
inc VAT, North Wales guide

Five or more rooms or two outdoor units.

Prices are shown before any Boiler Upgrade Scheme grant. The £2,500 air-to-air grant applies only to eligible homes in England and Wales, using an MCS-certified heat pump installed by an MCS-certified installer, who applies for the grant and deducts it from the price. We confirm eligibility, and which installer applies, before you commit.

Guide prices show VAT at 20%. HMRC treats most fixed air conditioners and air-to-air heat pumps installed in homes as energy-saving materials, zero-rated until 31 March 2027 when we supply and fit them. If your installation qualifies, your quote shows 0% VAT and a lower price. Servicing, repairs, cleaning and controls are charged at 20%.

Planning and permissions

In Wales, outdoor units of up to 1.5 m³ that meet MCS 020a noise limits are usually permitted development on houses; listed buildings need consent, and in conservation areas a unit cannot go on a wall or roof facing a road.

Mold is in the Boiler Upgrade Scheme area, so eligible homes replacing oil, gas, LPG or electric heating may be able to get £2,500 off an air-to-air heat pump, as long as no fossil-fuel boiler stays in use. An MCS-certified installer must claim it; we confirm eligibility, and which installer applies, before you commit.

The survey

On a survey in Mold the engineer looks at room size, glazing, the route for pipes and drains, the electrics and where the outdoor unit can sit quietly, then the written quote follows. At the survey we look at how each room is used, where the sun hits it and how the pipes can reach the outside wall, then put it all in a written quote.

What is included

Every job in Mold includes:

  • Air-to-air system sized for winter
  • Boiler Upgrade Scheme eligibility check
  • Commissioning and controls set-up
  • Disconnection and removal of old heaters
  • Free survey and heat-loss calculation

Nearby

Nearby, we also cover Buckley (2 miles), Deeside (5 miles) and Hawarden (5 miles). See all services in Mold or storage and electric heater replacement across Clwyd.

FAQ

Common questions in Mold

Can I get a price for Mold without a visit?

Yes, our online guide price tool gives a range in about a minute. A fixed price needs a survey, which is free for new installations.

How much does storage and electric heater replacement cost in Mold?

Our guide range in North Wales is £3,245–£9,795 for 3–5 rooms, including VAT. The exact price depends on the rooms, the pipe route and access, and we confirm it in writing after a free survey.

Do you cover all of Mold?

Yes, including CH7. We also cover nearby Buckley and Deeside.

Who carries out the work in Mold?

F-gas certified engineers working for Aircon Installers. Your contract is with S&K Property Investments and Improvement Ltd, which trades as Aircon Installers, and your quote names who will do the work and the F-gas company certificate that covers it.

Will an air-to-air heat pump be cheaper than storage heaters?

In most homes running costs fall significantly, because the heat pump uses a fraction of the electricity for the same heat.

Next step

Ready for a cooler summer and a cheaper winter?

Book a survey, or get a guide price in about a minute with our online tool.

Starting a live chat loads Tawk.to, which sets its own cookies. Cookie policy.

CallGet a quote